6WINDGate™ WEBGate - System: General setup

6WINDGate™ WEBGate Configuration

admin Logout

System
     General setup
     ARP and NDP
     Update Firmware
Interfaces
     Assign role
      eth0_0 (lan)
      eth1_0 (lan)
      eth2_0 (lan)
     Dynamic interfaces
Firewall
     Rules
Services
     DNS forwarder
     Dynamic DNS
     SNMP
     IPv4 DHCP Relay
     IPv4 DHCP Server
     IPv6 DHCP Client
     IPv6 DHCP Server
     IPv6 Mobility
     NAT & NAT-PT
     PPP Server
     PPPoE Server
     L2TP Server
     AAA
VPN
     IPsec
     Certificates
     VPN Templates
Migration
     Xin4
     6to4
     Xin6
     DSTM
     ISATAP
Routing
     Static Routes
     RIP
     RIPng
     OSPF
     BGP
     ISIS
     PIM-SMv4
     PIM-SMv6
Logs
     Log Sessions
     Log Services
     Show Log Sessions
Status
     System
     Show Status
     Interfaces
     Show Route
     DHCP leases
     IPsec SA/SPD
     Ping
     Backup/Restore
     Reboot system

System: General setup

The configuration has been changed.
You must apply the changes in order for them to take effect.

Hostname	name of the firewall host, without domain part e.g. firewall
Domain	e.g. mycorp.com
Time zone	Select the location closest to you
Time update interval	Minutes between network time sync.; 300 recommended, or 0 to disable
NTP time server	Use a space to separate multiple hosts (only one required). Remember to set up at least one DNS server if you enter a host name here!

Telnet - SSH - HTTP services

Enable telnet service

Enable SSH service

Enable HTTP service

6WINDGate™ WEBGate protocol	HTTP HTTPS
6WINDGate™ certifcate name	Enter router's certificate when starting 6WINDGate™ WEBGate in secure mode (https). Use VPN/certificates to add router's certificate
6WINDGate™ WEBGate port	Enter a custom port number for the 6WINDGate™ WEBGate above if you want to override the default port (default port is 80).

Host-IP Address Table

Hostname	IP address

DNS Servers

Nameserver IP addresses