6WINDGate™ WEBGate Configuration
admin  Logout  
System
     General setup
     ARP and NDP
     Update Firmware
Interfaces
     Assign role
      eth0_0 (lan)
      eth1_0 (lan)
      eth2_0 (lan)
     Dynamic interfaces
Firewall
     Rules
Services
     DNS forwarder
     Dynamic DNS
     SNMP
     IPv4 DHCP Relay
     IPv4 DHCP Server
     IPv6 DHCP Client
     IPv6 DHCP Server
     IPv6 Mobility
     NAT & NAT-PT
     PPP Server
     PPPoE Server
     L2TP Server
     AAA
VPN
     IPsec
     Certificates
     VPN Templates
Migration
     Xin4
     6to4
     Xin6
     DSTM
     ISATAP
Routing
     Static Routes
     RIP
     RIPng
     OSPF
     BGP
     ISIS
     PIM-SMv4
     PIM-SMv6
Logs
     Log Sessions
     Log Services
     Show Log Sessions
Status
     System
     Show Status
     Interfaces
     Show Route
     DHCP leases
     IPsec SA/SPD
     Ping
     Backup/Restore
     Reboot system

PIM-SMv6: General Setup

The configuration has been changed.
You must apply the changes in order for them to take effect.

Reverse Path Forwarding

RPF
Choose Reverse Path Forwarding.

RP Candidate

  candidate for RP election
Interface
Interface for candidate RP advertisements.
e.g.eth1, eth2, ...
Priority
RP candidate priority. Default value is 0 (highest prioirty).

BSR Candidate

  candidate for BSR election
Interface
Interface for candidate BSR advertisements.
e.g.eth1, eth2, ...
Priority
BSR candidate priority. Default value is 0 (lowest priority).

Threshold

Data
Rate:     Interval:  

Specifies the threshold that a last hop router switches to a shortest path tree.
The default value of rate and interval are 50000 (bits/s) and 20, respectively.
Register
Rate:     Interval:  

Specifies the threshold that a RP switches to a shortest path tree.
The default value of rate and interval are 50000 (bits/s) and 20, respectively.

Timers

Hello holdtime
period:     coef:  

Specifies the period in second between 2 hello messages.
The holdtime will be period * coef.
The default values of the period and the coefficient are 30 and 3.5, respectively.
Join/Prune holdtime
period:     coef:  

Specifies the period in second between 2 join/prune mes-sages.
The holdtime will be period * coef.
The default values of the period and the coefficient are 60 and 3.5, respectively.
Data timeout
Specifies the time (in seconds) after which (S,G) state for a silent source will be deleted.
e.g 1 to 65535. The default value is 210.
Register-Stop timeout
specifies the interval (in seconds) between receiving a Register-Stop and allowing PIM Register to be send again.
e.g 1 to 65535. The default value is 60.
Probe time
Specifies the time (in seconds) between sending a null Register and the Register-Suppression-Timer expiring.
e.g. 1 to 65535. The default value is 5.
Assert timeout
Specifies Assert timeout interval in seconds.
e.g. 1 to 65535. The default value is 180

Networks

Intf mld pref metric llqi robustness query interval query respond interval

Static RP

Address multicast group priority

Group prefixes

Group prefix
   
6WINDGate™ WEBGate. All rights reserved.  [view license]