6WIND WEBGate - Interfaces: Access Point: Edit Interface

6WINDGate™ WEBGate Configuration

admin Logout

System
     General setup
     ARP and NDP
     Update Firmware
Interfaces
     Assign role
      eth0_0 (lan)
      eth1_0 (lan)
      eth2_0 (lan)
     Dynamic interfaces
Firewall
     Rules
Services
     DNS forwarder
     Dynamic DNS
     SNMP
     IPv4 DHCP Relay
     IPv4 DHCP Server
     IPv6 DHCP Client
     IPv6 DHCP Server
     IPv6 Mobility
     NAT & NAT-PT
     PPP Server
     PPPoE Server
     L2TP Server
     AAA
VPN
     IPsec
     Certificates
     VPN Templates
Migration
     Xin4
     6to4
     Xin6
     DSTM
     ISATAP
Routing
     Static Routes
     RIP
     RIPng
     OSPF
     BGP
     ISIS
     PIM-SMv4
     PIM-SMv6
Logs
     Log Sessions
     Log Services
     Show Log Sessions
Status
     System
     Show Status
     Interfaces
     Show Route
     DHCP leases
     IPsec SA/SPD
     Ping
     Backup/Restore
     Reboot system

Interfaces: Access Point: Edit Interface

The configuration has been changed.
You must apply the changes in order for them to take effect.

Access Point

Interface name	ap e.g. ap0, ap1, ...
Bind	Bind to wifiX interface
SSID	Configure access point SSID (up to 32 characters)
Authentication mode	Authentication open Authentication shared (require static WEP keys)
AP maximum inactivity	Configure AP maximum inactivity in seconds (default 300s)

WEP Parameters

WEP keys

Make WEP key 0 default key
Make WEP key 1 default key
Make WEP key 2 default key
Make WEP key 3 default key
Do not use any WEP key as default

MAC-Based Access Control

Access control mode	Accept or deny only specified hosts
Access control database	Select the local AAA database to use for MAC access control

WPA Parameters

WPA version	WPA (IEEE 802.11i/D3.0) WPA2 (full IEEE 802.11i/RSN)
WPA key management	WPA-PSK, will require a secret passphrase WPA-EAP, will require to configure a radius server and enable EAP server
WPA cypher suites	Temporal Key Integrity Protocol (IEEE 802.11i/D7.0, preferred method) AES in Counter mode with CBC-MAC (RFC 3610, IEEE 802.11i/D7.0)
WPA passphrase	Secret passphrase (8 to 63 characters)
WPA strict rekying	Rekey GTK when any station leaves the AP
WPA group rekey	Time interval for rekeying GTK (broadcast/multicast enryption keys, default 600s)
WPA master key rekey	Time interval for rekeying GMK (master key used internally to generate GTKs, default 86400s)
Enable EAP server	Enable EAP server
Users database	Select the local AAA database to use for WPA users parameters
CA certificate	Select the certification authority certificate to use
Server certificate	Select the certificate to use
Private key	Select the private key to use
Private key password	Private key password

Radius Server

Radius server	Server address Server password
Type	Accounting Authentication